Skip to main content
A campaign is a Workflow that starts with Run for every record in a list: it runs for every record in a List and has steps that reach people outside your workspace, such as a LinkedIn message, an email or a call. Campaigns is the second row of your SDR’s Outbound group in the sidebar. Where: sidebar → Campaigns · https://connie.ai/<workspace-id>/campaigns

The Campaigns page

The page lists your campaigns in the same table as the Campaigns tab of Artifacts: Name, Status, Created by and Last run. Its tabs filter by status: All, Live, Paused and Drafts, each with its count. Search campaigns… narrows the list by name or creator, and the tab counts then count only the campaigns that match. A Workflow counts as a campaign when it runs for every record in a List and at least one of its steps reaches a person, or when it has no step besides that start yet (a campaign you just started, listed as a Draft). The list shows the campaigns you can open, as the Workflows list does. In a very large workspace only your most recently active Workflows are checked; the page then says “Only your most recently active Workflows were checked, so an older campaign may be missing.” Click a campaign to open it in the Workflow builder. Its breadcrumb leads back to Campaigns. A row’s More actions menu offers the same actions as in Artifacts. With no campaign yet, the page says No campaigns yet: “Reach a List of people by LinkedIn, email or phone. Your campaigns show up here.” If the list can’t load, it says Could not load campaigns with Try again.

Start a campaign

1

Click New campaign

On the Campaigns page, click New campaign at the top right. Your SDR’s chat opens with a new campaign beside it, as New workflow in Artifacts does. The campaign is a real Workflow named Untitled campaign, already set to Run for every record in a list, and the Campaigns page lists it as a Draft straight away.
2

Tell your SDR what to build

The message box holds a request ready for you, unsent: review it, add who the campaign should reach and what it should send, and send it. Your SDR builds the campaign in the panel beside the chat, where you can also add and change steps yourself. Until the campaign has loaded there, the panel says “Describe your campaign in the chat to get started.”
If the chat or the campaign can’t open, Connie says why, usually “Couldn’t open your campaign. Please try again.” Click New campaign again without leaving the page: the same campaign is used, so no second one is made. Workspace guests have no agent: they are told Only workspace members have an agent to build a campaign with. A Workflow you build yourself is a campaign too, once it starts with Run for every record in a list and has a step that reaches a person. You can also ask your SDR in its chat to build a campaign: it builds each campaign as a Workflow, so you can see and change it, and asks before it starts sending.